Facilities

Nova Technology is located in East Hanover NJ, minutes from Interstates’ 80, 287 and 280. Less than 25 miles from Newark International Airport and New York City. Our 8000 sq. ft. building houses conference rooms, design offices, a full machine shop, an electronics lab, training areas, and a prototype testing facility.

During the development phase of a new project, we will build accurate mockups to assist in prototype design and operator interface. The mockups are then used to thoroughly test robotics, qualify inspection tooling, train new operators, and assist in writing technical documentation.

Click Here For A Map

In our 2400 sq. ft. training center, we have a 5000-gallon water tank used for testing underwater vehicles, cameras, tooling, and manipulators. Utilizing overhead cranes, we can place full scale mockups into the tank for underwater testing, camera resolution checking, and advanced operator training.

The training center can be completely "blacked out" for testing light sensitive equipment and ultraviolet inspection techniques. Trainees can be observed and supervised from an observation room located on the second floor of the training bay.

Our electronics lab is equipped with advanced diagnostic tools that technicians use to quickly and accurately troubleshoot and repair the most complex digital circuits. Prototype circuits can be designed, produced, and tested before incorporating them into robotic systems. After the circuit is fully tested and approved, a printed circuit board is fabricated at an off-site facility. Multiple printed circuit boards can be easily and inexpensively mass produced while minimizing labor costs.

Our in-house precision machine shop consists of several milling machines, lathes, grinders and a wide array of specialty tooling that allow us to quickly and accurately fabricate complex machine components. Our computer controlled CNC mill allows us to produce identical components when small tolerances and large quantities are needed.